When button testing units in sequence it is important to wait 15 seconds plus a further 6 seconds per
repeater between button tests (e.g. for a system with 10 repeaters, time to wait: 15 seconds + 10 x 6
seconds = 75 seconds between button tests).
Finally attach the label provided to the distribution board to identify the alarm circuits.
(Note: If it is necessary to clear House Codes see section 12, page 31 - Technical Specification).
The “Repeater” Function
All Ei262 CO Alarms are set as “Repeater” units as supplied. The function of a Repeater unit is to receive
and then re-transmit the RF signals. This provides multiple signal paths throughout the installation to give
improved RF signal reliability (with 3 or more RadioLINK units).
Note the “Repeater” function is not operational until all the units are put in to House Code mode.
The operation of the “Repeaters” can be observed as each unit turns on its RadioLINK Indicator light as a
RadioLINK message is being repeated.
(Note: If it is necessary to disable the Repeater function see section 12, page 32 - Technical Specification).
4.2.2 RadioLINK Accessories
When using RadioLINK accessories simply install all the units as per their instructions first. Then
follow the House Coding and checking procedure described in 4.2.1 above.
5. USING AND TESTING YOUR SYSTEM
5.1 Using the System
If the Alarm is sounding (with its red alarm indicator flashing at least once every 2 seconds) – immediately
follow the instructions on page 3 “What to do when the Carbon Monoxide Alarm is activated”.
If you have interconnected CO Alarms and Smoke/Heat Alarms and they are all in alarm, then quickly
press the “Locate” button (on the Ei411H Remote Control Switch) to silence all the alarms except the
one sensing danger.
20
To Next Page
Loading...
Need help?
General
