To Next PageTo Next PageWhat to do if my EINHELL Pole Saw chainsaw does not work at all?
If your EINHELL Pole Saw chainsaw isn't working, several factors could be the cause. First, check the power supply. If that's not the issue, the mains outlet might be defective; try an alternative power source or replace the outlet. Inspect the power extension cable for damage and replace it if necessary. Finally, a defective fuse could be the culprit, so replace the fuse.
Why is my EINHELL BG-EC 620 T chain/guide rail hot?
If the chain or guide rail of your EINHELL Pole Saw is getting hot, it could be due to several reasons. Check if there is oil in the tank and fill it up if it's empty. Also, the oil tank cap breather might be blocked, so clean it. Another possibility is a blocked oil outlet, which you should clear. Lastly, a blunt chain can cause overheating, so re-sharpen or replace the chain.
What to do if my EINHELL BG-EC 620 T chainsaw is juddering, vibrating or not sawing properly?
If your EINHELL Pole Saw chainsaw is juddering, vibrating, or not sawing properly, start by checking the chain tension and adjust it if it's too loose. A blunt chain could also be the cause, so re-sharpen or replace it. If the chain is worn, replace it. Finally, ensure the saw teeth are pointing in the correct direction; if not, reinstall the saw chain correctly.
What to do if my EINHELL Pole Saw chain is dry?
If the chain on your EINHELL Pole Saw is dry, the possible reasons are: there is no oil in the tank, so you should fill it up with oil; the oil tank cap breather is blocked, so you should clean the oil tank cap; the oil outlet is blocked, so you should clear the oil outlet.
General| Power | 620 W |
|---|---|
| Power source | Electric |
| Voltage | 230 V |
| Bar Length | 20 cm |
| Weight | 3.9 kg |
| Oil tank volume | 110 ml |
| Cutting length | 18 cm |
Guide to attach the cutting bar and chain to the motor unit.
How to properly adjust the saw chain tension for safe and effective operation.
Instructions on filling and maintaining the automatic chain lubrication system.
Procedure for attaching the secondary handle for better control.
Steps for safely connecting the electric pole pruner to the power source.
Methods for efficiently cutting branches of various sizes.
Understanding kickback hazards and preventative measures.
Steps for replacing worn or damaged cutting components.
