EINHELL GE-LC 18 Li T

Other manuals for EINHELL GE-LC 18 Li T

Original Operating Instructions140 pages

Questions and Answers

M
Michael WhiteAug 8, 2025
Why is the chain/guide bar on my EINHELL GE-LC 18 Li T Pole Saw hot?
- R
  Robert WilliamsAug 8, 2025
  If the chain or guide bar of your EINHELL Pole Saw is hot, it could be due to several reasons. First, check if there is enough oil in the tank and top it up if necessary. A blocked vent in the oil tank cap can also cause this issue, so clean the cap. Additionally, clear any blockage in the oil outlet. If these steps don't resolve the problem, the chain might be blunt and needs re-sharpening or replacement. Lastly, check the chain tension, as an overtensioned chain can also lead to overheating.
L
lori69Aug 13, 2025
How to fix a dry saw chain on my EINHELL GE-LC 18 Li T?
- S
  Shelby SnyderAug 13, 2025
  If your EINHELL Pole Saw chain is dry, there might be a few reasons. Start by checking the oil level in the tank and top it up if it's low. Also, the vent in the oil tank cap might be blocked, so try cleaning it. Finally, the oil outlet could be blocked, so clear it to ensure proper lubrication.
A
Andrea CohenAug 18, 2025
What to do if my EINHELL GE-LC 18 Li T Pole Saw chain judders or doesn't saw properly?
- G
  Grant MckayAug 18, 2025
  If your EINHELL Pole Saw chain saw judders, vibrates, or does not saw properly, several issues could be the cause. Start by checking the chain tension and adjust it if it's undertensioned. The chain might also be blunt, requiring re-sharpening or replacement. If the chain is worn, replace it. Finally, ensure the saw teeth point in the correct direction; if not, refit the chain properly.
T
Timothy MarksAug 25, 2025
Why is the chain/guide bar hot on my EINHELL Cordless Saw?
- E
  Emily BaileyAug 25, 2025
  If the chain or guide bar of your EINHELL Cordless Saw gets hot, it could be due to several reasons: * There might be no oil in the tank, so top it up with oil. * The vent in the oil tank cap could be blocked; clean the oil tank cap. * The oil outlet may be blocked; clear the oil outlet. * The chain could be blunt, requiring re-sharpening or replacement. * The chain might be overtensioned; check and adjust the chain tension.
H
hannah14Aug 28, 2025
Why does my EINHELL Cordless Saw judder, vibrate, or not saw properly?
- J
  Jeffery Fox DDSAug 28, 2025
  If your EINHELL Cordless Saw judders, vibrates, or doesn't saw properly, consider the following: * The chain might be undertensioned. In this case, adjust the chain tension. * The chain could be blunt, so re-sharpen or replace it. * The chain might be worn, necessitating replacement. * The saw teeth could be pointing in the wrong direction; refit the chain with the teeth facing the correct direction.
J
jacquelinethompsonSep 2, 2025
Why is the saw chain dry on my EINHELL Cordless Saw?
- K
  Kyle JohnsonSep 2, 2025
  If the saw chain on your EINHELL Cordless Saw is dry, it could be due to: * No oil in the tank. Solution: Top up with oil. * A blocked vent in the oil tank cap. Solution: Clean the oil tank cap. * A blocked oil outlet. Solution: Clear the oil outlet.