7
Important.
When using the equipment, a few safety
precautions must be observed to avoid injuries
and damage. Please read the complete
operating instructions and safety regulations
with due care. Keep this manual in a safe
place so that the information is available at all
times. If you give the equipment to any other
person, hand over these operating instructions
and safety regulations as well. We cannot
accept any liability for damage or accidents
which arise due to a failure to follow these
instructions and the safety instructions.
1. Layout (Fig. 1)
1. Carry handle
2. Welding current scale
3. ON/OFF switch
4. Earth terminal
5. Electrode holder
6. Hand wheel for welding current
7. Warning lamp for overheating
8. Slag hammer with brush
9. Welding screen
2. Items supplied (Figure 1+2)
앬 Welding set
앬 Welding area equipment
3. Important information
The equipment is to be used only for its
prescribed purpose. Any other use is deemed
to be a case of misuse. The user / operator
and not the manufacturer will be liable for any
damage or injuries of any kind caused as a
result of this.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be
voided if the equipment is used in commercial,
trade or industrial businesses or for equivalent
purposes.
Please read the operating instructions carefully
and observe the information provided.It is
important to consult these instructions in order
to acquaint yourself with the equipment, its
proper use and safety regulations.
The reprinting or reproduction by any other
means, in whole or in part, of documentation
and papers accompanying products is
permitted only with the express consent of ISC
GmbH.
Subject to technical changes
Safety Regulations
Please note
Warning!
Use this equipment only for the purpose for
which it is designed, as described in these
instructions: Manual arc welding with coated
electrodes. Handling this system incorrectly
may be hazardous for persons, animals and
property and may result in fires burning
buildings, electric shocks, eye injuries, etc. The
user of this system is responsible for his/her
own safety and for the safety of others. Read
these operating instructions and follow all the
regulations.
앬 Repairs and/or maintenance work must be
left strictly to qualified personnel.
앬 Only use the welding cables supplied (Ø 10
mm
2
rubber-sheathed welding cables).
앬 Ensure that the appliance is looked after
properly.
앬 To ensure that sufficient air can be drawn
in through the ventilation slits, the
equipment should not be constricted or
placed next to a wall while it is in operation.
Make sure that the appliance is correctly
connected to the mains supply (see 6.). Do
not subject the mains lead to any tensile
stress. Unplug the appliance before you
change its position.
앬 Check the condition of the welding cables,
the electrode holder and the earth
terminals; wear on the insulation and the
GB
To Next Page
Loading...
