GB
- 57 -
11. Charging station display and troubleshooting
LED display (19a) Description Solution
Off - No power supply - Check the power supply
Lit green - Ready for mowing
- The battery is fully charged
- The guide cable (24) is con-
nected
Flashing green - The guide cable (24) is se-
vered
- Examine the guide cable (24) for a break
Lit red - The battery is being charged - Wait until the battery is fully charged
12. Robot lawn mower display and troubleshooting
Rain sensor LED
(53)
Description / possible cause Solution
Flashing yellow - The rain sensor (5) has trip-
ped.
- Wait until the robot lawn mower is dry.
- A detailed description of the sensor can
be found in section 5.2.
GNSS LED (54) Description / possible cause Solution
Flashing green - The robot lawn mower
searches for a GNSS con-
nection and calibrates the
position of the charging stati-
on (19).
- The GNSS signal is not pre-
cise
- Wait for calibration to end.
- If the GNSS LED (54) fl ashes perma-
nently, the received signal is very weak
(blocked by a building or tree) and the po-
sition of the charging station (19) should
be adapted.
Lit green - The robot lawn mower has
calibrated the position pf the
charging station (19) with the
help of GNSS.
- The GNSS signal is precise
- The robot lawn mower is ready.
Flashing yellow - There is no GNSS signal - Make sure that the robot lawn mower is
outside and that the GNSS signal is not
being blocked.
Lit yellow - The robot lawn mower is too
far from the charging station
(19).
- Move the robot lawn mower into the mo-
wing area which is near the charging stati-
on (19).
- Switch off the main switch (7) (OFF) and
then switch it back on again (ON) to re-
start the robot lawn mower.
Lit red - Hardware fault on the GNSS
module
- Contact your customer service center.
Anl_FREELEXO_CAM_SPK13.indb 57Anl_FREELEXO_CAM_SPK13.indb 57 01.12.2022 15:35:2401.12.2022 15:35:24
To Next Page
Loading...
