GB
- 63 -
Troubleshooting
Fault Possible cause Remedy
The robot lawn mo-
wer cannot fi nd the
charging station
- The charging station (19) is
in a position that receives
only a weak GNSS signal
- Obstacles in the immediate
vicinity of the guide cable
loop are preventing the mo-
wer from reaching the loop.
- Adapt the position of the charging station
(19) and delete the mapping as described
in the operating instructions.
- Adapt the shape of the guide cable loop /
enlarge the guide cable loop.
IMPORTANT! A severed guide cable and consequential damages are not covered by the war-
ranty!
Magnetic tape troubleshooting (27)
Fault Possible cause Remedy
The robot lawn
mower fails to
recognize the mag-
netic tape (27) and
travels over it and
past it.
- The magnetic tape (27) is
laid too deep in the ground.
- The magnetic tape (27) does
not work properly because
the outside temperature is
too high.
- Lay the magnetic tape (27) on the ground
or at a depth of approx. 5 cm in the
ground.
- Wait for the temperature to cool. Avoid
operating the robot lawn mower during the
hot hours of the day.
The robot lawn mo-
wer stops or travels
out of control when
it is near the bound-
ary area.
- The magnetic tape (27) is
laid too close to the guide
cable (24). The distance
between two independent
boundary areas with magne-
tic tape (27) is too small.
- Interference arises in the
mowing area due to electric
cables.
- Keep a distance of at least 80 cm bet-
ween the guide cable (24) and the mag-
netic tape (27) or between two boundary
areas.
- Avoid electric cables which run through
the mowing area. Position the charging
station (19) at the edge of the mowing
area. Keep away from mowed areas which
do not belong to you but to your neigh-
bors, for example, and which are operated
with a perimeter wire.
The robot lawn mo-
wer intrudes in the
boundary area.
- The robot lawn mower slips
over the magnetic tape (27).
- Avoid laying the magnetic tape (27) on
gradients.
- Take account of the specifi ed conditions
of installation.
Anl_FREELEXO_CAM_SPK13.indb 63Anl_FREELEXO_CAM_SPK13.indb 63 01.12.2022 15:35:2701.12.2022 15:35:27
To Next Page
Loading...
