GB
- 42 -
9. Troubleshooting guide
Warning: Switch off the engine and pull out the spark plug boot before making any checks or adjust-
ments.
Warning: If, after making an adjustment or repair to the engine, you let it run for a few minutes, remem-
ber that the exhaust and other parts will get hot. Do not touch these parts as they may burn you.
Fault Possible cause Remedy
The equipment
does not operate
smoothly and vibra-
tes intensively
- Bolts loose
- Blade attachment is loose
- Blade imbalanced
- Check bolts
- Check blade attachment
- Replace blade
The engine does
not start
- Engine start/stop lever is not
pressed
- Spark plug defective
- Fuel tank empty
- Press the engine start/stop lever
- Replace spark plug
- Top up fuel
Engine does not run
smoothly
- Air fi lter dirty
- Spark plug dirty
- Clean the air fi lter
- Clean the spark plug
Lawn turns yellow,
uneven cut
- Blade is not sharp
- Cutting height too small
- Sharpen blade
- Adjust to the proper height
Grass chute is not
clean
- Cutting height too small
- Blade is worn
- Grass bag is clogged
- Set properly
- Replace the blade
- Empty the grass bag
The battery does
not charge up
- Poor plug contact to the battery
- Battery defective
- 5A fuse (Item 19) is defective
- Clean the contacts
- Have the battery checked by an
expert and replace it if necessary
- Check the function of the equip-
ment using a diff erent battery; re-
place the fuse
Starter does not
turn
- Battery discharged
- Battery not connected
- No plug-in connections
- Charge the battery
- Connect the battery
- Check the plug-in connections
Anl_GC_PM_51_2_S_HW_E_SPK9.indb 42Anl_GC_PM_51_2_S_HW_E_SPK9.indb 42 06.08.2019 08:41:4506.08.2019 08:41:45
To Next Page
Loading...
Need help?
General
Weight and Dimensions
