gloves! Only replace the blade with a genuine Eichel replacement blade, as this will ensure top performance and
safety under all conditions.
Carry out the following steps to change the blade:
1. Undo the fastening screw (see Fig. 13).
2. Remove the blade and replace with a new one.
3. When thing the blade, make sure it is installed in the right direction. The blades air vanes must project into the
motor compartment (see Fig. 13). The dome mounts must be aligned with the punch holes in the blade.
4. Then retighten the fastening screw with the universal wrench. The tightening torque should be approx. 25 Nm.
At the end of the season, perform a general inspection of the lawn mower and remove any grass and dirt which may
have accumulated. At the start of each season, ensure that you check the condition of the blade. If repairs are
necessary, please contact our customer service center. Use only genuine spare parts.
7.4 Ordering replacement parts:
Please quote the following data when ordering replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to www.isc-gmbh.info
Spare blade art. no.: 34.054.52
8. Storage and transport
Storage
Store the equipment and accessories out of children’s reach in a dark and dry place at above freezing temperature.
The ideal storage temperature is between 5 and 30 °C. Store the machine in its original packaging.
Transport
Switch the machine off and isolate it from the power supply before transporting it.
Fit the shipping protectors, if any.
Protect the machine from damage and the strong vibrations that can occur particularly when transporting in
vehicles.
Secure the machine against slipping and tipping over.
9. Disposal and recycling
The equipment is supplied in packaging to prevent it from being damaged in transit. The raw materials in this
packaging can be reused or recycled. The equipment and its accessories are made of various types of material, such
as metal and plastic. Never place defective equipment in your household refuse. The equipment should be taken to a
suitable collection center for proper disposal. If you do not know the whereabouts of such a collection point, you
should ask in your local council offices.
10. Troubleshooting
To Next Page
Loading...
