29
GB
10. Troubleshooting guide
Warning: Switch off the engine and pull out the ignition cable before making any checks or adjustments.
Warning: If, after making an adjustment or repair to the engine, you let it run for a few minutes, remember that
the exhaust and other parts will get hot. Do not touch these parts as they may burn you.
Fault Possible cause Remedy
The equipment does not operate
smoothly and vibrates intensively
- Bolts loose
- Blade attachment is loose
- Blade imbalanced
- Check bolts
- Check blade attachment
- Replace blade
The engine does not start - Brake lever not pushed
- Throttle lever in wrong position
- Spark plug defective
- Fuel tank empty
- Push brake lever
- Check setting
- Replace spark plug
- Top up fuel
Engine does not run smoothly - Air filter dirty
- Spark plug dirty
- Clean the air filter
- Clean the spark plug
Lawn turns yellow,
uneven cut
- Blade is not sharp
- Cutting height too small
- Engine speed too low
- Sharpen blade
- Adjust to the proper height
- Set the lever to max.
Grass chute is not clean - Engine speed too low
- Cutting height too small
- Blade is worn
- Grass bag is clogged
- Set the throttle lever to max.
- Set properly
- Replace the blade
- Empty the grass bag
To Next Page
Loading...
Need help?
General
