EINHELL GH-SP 2768 - User Manual

Questions and Answers

D
David JensenAug 10, 2025
Why does my EINHELL GH-SP 2768 switch off after briefly running?
- J
  Joshua MorrisAug 10, 2025
  Your EINHELL Water Pump might be switching off shortly after starting due to a couple of reasons: * The motor circuit-breaker might be tripping because of excessive water contamination. If this is the case, unplug the power and clean the equipment and shaft. * Alternatively, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Ensure that the water temperature does not exceed 35 °C.
M
Mrs. Julia WalkerAug 16, 2025
What to do if my EINHELL GH-SP 2768 does not start?
- S
  Stephanie HarrisAug 16, 2025
  If your EINHELL Water Pump doesn't start, there are a couple of things you can check: * First, make sure the power supply is properly connected. * Second, check the floating switch. If it's not triggering, raise its position.
J
Jeffrey WilsonAug 22, 2025
What to do if my EINHELL Water Pump does not pump water?
- G
  garciavanessaAug 22, 2025
  If your EINHELL Water Pump isn't pumping water, it could be due to a couple of issues: * The intake sieve might be clogged. If so, clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
A
Anna ValdezAug 27, 2025
Why EINHELL GH-SP 2768 Water Pump has insufficient pumping rate?
- R
  rcrawfordAug 28, 2025
  An insufficient pumping rate in your EINHELL Water Pump can occur due to: * A clogged intake sieve. Clean the intake sieve. * Reduced performance caused by heavily contaminated and abrasive water impurities. Clean the equipment and replace any worn parts.
R
Robert McgrathSep 3, 2025
What to do if my EINHELL GH-SP 2768 Water Pump does not cut out?
- L
  Lisa MuellerSep 3, 2025
  If your EINHELL Water Pump isn't cutting out, it might be because the floating switch can't sink. Ensure the equipment is correctly placed on the shaft bottom.

EINHELL GH-SP 2768 Specifications

General

Power	270 W
Max Flow Rate	6800 L/h
Max Suction Depth	5 m
Max Immersion Depth	5 m
Max Water Temperature	35 °C
Mains Supply	230 V ~ 50 Hz
Voltage	230 V
Frequency	50 Hz