What to do if my EINHELL GC-DP 1020 N does not start?
If your EINHELL Water Pump doesn't start, there are a couple of things you can check: * First, make sure the power supply is properly connected. * Second, check the floating switch. If it's not triggering, raise its position.
Why does my EINHELL GC-DP 1020 N Water Pump switch off after briefly running?
Your EINHELL Water Pump might be switching off shortly after starting due to a couple of reasons: * The motor circuit-breaker might be tripping because of excessive water contamination. If this is the case, unplug the power and clean the equipment and shaft. * Alternatively, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Ensure that the water temperature does not exceed 35 °C.
What to do if my EINHELL GC-DP 1020 N Water Pump does not pump water?
If your EINHELL Water Pump isn't pumping water, it could be due to a couple of issues: * The intake sieve might be clogged. If so, clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
Why EINHELL GC-DP 1020 N Water Pump has insufficient pumping rate?
An insufficient pumping rate in your EINHELL Water Pump can occur due to: * A clogged intake sieve. Clean the intake sieve. * Reduced performance caused by heavily contaminated and abrasive water impurities. Clean the equipment and replace any worn parts.
What to do if my EINHELL Water Pump does not cut out?
If your EINHELL Water Pump isn't cutting out, it might be because the floating switch can't sink. Ensure the equipment is correctly placed on the shaft bottom.
Overview of the pump's components and their identification numbers.
Lists all components included in the product packaging.
Instructions and considerations for installing the pump for operation.
Safe procedures for connecting the pump to the electrical power supply.
Step-by-step guide for cleaning the paddle wheel mechanism.
Information on internal maintenance requirements for the equipment.
Details to provide when ordering spare parts for the machine.
General| AC input voltage | 230 V |
|---|---|
| AC input frequency | 50 Hz |
| Flow rate | 18000 l/h |
| Motor power | - hp |
| Maximum delivery height | 9 m |
| Depth of immersion (max) | 5 m |
| Maximum operating pressure | - bar |
| Solid particles size (max) | 20 mm |
| Maximum input water temperature | 35 °C |
| Cable length | 10 m |
| Suction port | 1\ |
| Connecting thread type | - |
| Proper use | What is the intended application of the product? |
| Product color | Red, Silver |
| Housing material | Stainless steel |
| Dimensions (WxDxH) | 170 x 235 x 415 mm |
| Carrying handle(s) | Yes |
| Quantity | 1 |
Weight and Dimensions| Depth | 225 mm |
|---|---|
| Width | 170 mm |
| Height | 415 mm |
| Weight | 7200 g |
| Package weight | 7800 g |
To Next Page