To Next PageTo Next PageWhat to do if my EINHELL Water Pump does not start?
If your EINHELL Water Pump doesn't start, there are a couple of things you can check: * First, make sure the power supply is properly connected. * Second, check the floating switch. If it's not triggering, raise its position.
Why does my EINHELL GC-DP 3325 switch off after briefly running?
Your EINHELL Water Pump might be switching off shortly after starting due to a couple of reasons: * The motor circuit-breaker might be tripping because of excessive water contamination. If this is the case, unplug the power and clean the equipment and shaft. * Alternatively, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Ensure that the water temperature does not exceed 35 °C.
What to do if my EINHELL Water Pump does not pump water?
If your EINHELL Water Pump isn't pumping water, it could be due to a couple of issues: * The intake sieve might be clogged. If so, clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
Why EINHELL GC-DP 3325 has insufficient pumping rate?
An insufficient pumping rate in your EINHELL Water Pump can occur due to: * A clogged intake sieve. Clean the intake sieve. * Reduced performance caused by heavily contaminated and abrasive water impurities. Clean the equipment and replace any worn parts.
What to do if my EINHELL GC-DP 3325 does not cut out?
If your EINHELL Water Pump isn't cutting out, it might be because the floating switch can't sink. Ensure the equipment is correctly placed on the shaft bottom.
General| Type | Impulse pump |
|---|---|
| Proper use | Garden, Pond |
| Product color | Black, Red |
| Suitable for indoor use | No |
| Suitable for outdoor use | Yes |
| Flow rate | 9500 l/h |
| Maximum suction height | 7 m |
| Maximum delivery height | 6 m |
| Maximum operating pressure | - bar |
| Maximum input water temperature | 35 °C |
| AC input voltage | 230 V |
| Power cable type | H05RN-F |
| Power source type | AC |
| AC input frequency | 50 Hz |
| Quantity per pack | 1 pc(s) |
| Cable length | 10 m |
Weight and Dimensions| Depth | 226 mm |
|---|---|
| Width | 172 mm |
| Height | 313 mm |
| Weight | 2870 g |
Identifies the main components of the pump, including handle, floating switch, and hose connection.
Details on checking the contents of the packaging and inspecting for transport damage.
Provides guidance on static installation methods and necessary safety precautions.
Details the required electrical connection, emphasizing safety and proper grounding.
Explains how to adjust the floating switch for automatic operation and prevent dry running.
Describes how to operate the pump manually and the precautions required.
Instructions for dismantling and cleaning the paddle wheel to remove deposits.
States that there are no internal parts requiring additional maintenance.
Lists the information needed when ordering replacement parts for the pump.
