What to do if my EINHELL GC-DP 3730 does not start?
If your EINHELL Water Pump doesn't start, there are a couple of things you can check: * First, make sure the power supply is properly connected. * Second, check the floating switch. If it's not triggering, raise its position.
Why does my EINHELL GC-DP 3730 Water Pump switch off after briefly running?
Your EINHELL Water Pump might be switching off shortly after starting due to a couple of reasons: * The motor circuit-breaker might be tripping because of excessive water contamination. If this is the case, unplug the power and clean the equipment and shaft. * Alternatively, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Ensure that the water temperature does not exceed 35 °C.
What to do if my EINHELL Water Pump does not pump water?
If your EINHELL Water Pump isn't pumping water, it could be due to a couple of issues: * The intake sieve might be clogged. If so, clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
Why EINHELL Water Pump has insufficient pumping rate?
An insufficient pumping rate in your EINHELL Water Pump can occur due to: * A clogged intake sieve. Clean the intake sieve. * Reduced performance caused by heavily contaminated and abrasive water impurities. Clean the equipment and replace any worn parts.
What to do if my EINHELL GC-DP 3730 Water Pump does not cut out?
If your EINHELL Water Pump isn't cutting out, it might be because the floating switch can't sink. Ensure the equipment is correctly placed on the shaft bottom.
Details the physical components of the pump.
Lists all parts included in the product packaging.
Details how to install the pump for operation.
Guide on adjusting the floating switch for automatic operation.
Instructions for cleaning the pump after use and periodically.
Information on internal maintenance requirements.
Details on how to order spare parts for the pump.
General| Type | Velocity pump |
|---|---|
| Proper use | Drainage, Water purification |
| Product color | Black, Red |
| Assembly required | No |
| Suitable for indoor use | - |
| Suitable for outdoor use | Yes |
| Flow rate | 9000 l/h |
| Grain size | 30 mm |
| Maximum suction height | 5 m |
| Maximum operating pressure | - bar |
| Maximum input water temperature | 35 °C |
| AC input voltage | 230 V |
| Power cable type | H05RN-F |
| Power source type | AC |
| AC input frequency | 50 Hz |
| Package weight | 5150 g |
| Quantity per pack | 1 pc(s) |
| Cable length | 10 m |
Weight and Dimensions| Depth | 220 mm |
|---|---|
| Width | 180 mm |
| Height | 400 mm |
| Weight | 4300 g |
To Next Page