EINHELL GC-DP 5225 N - User Manual

Questions and Answers

M
millercharlesAug 10, 2025
Why does my EINHELL GC-DP 5225 N Water Pump switch off after briefly running?
- H
  hjenkinsAug 10, 2025
  Your EINHELL Water Pump might be switching off shortly after starting due to a couple of reasons: * The motor circuit-breaker might be tripping because of excessive water contamination. If this is the case, unplug the power and clean the equipment and shaft. * Alternatively, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Ensure that the water temperature does not exceed 35 °C.
M
Melissa MurrayAug 16, 2025
What to do if my EINHELL GC-DP 5225 N Water Pump does not cut out?
- Z
  zpettyAug 16, 2025
  If your EINHELL Water Pump isn't cutting out, it might be because the floating switch can't sink. Ensure the equipment is correctly placed on the shaft bottom.
H
Heather ThompsonAug 23, 2025
What to do if my EINHELL GC-DP 5225 N does not start?
- C
  Cathy TaylorAug 23, 2025
  If your EINHELL Water Pump doesn't start, there are a couple of things you can check: * First, make sure the power supply is properly connected. * Second, check the floating switch. If it's not triggering, raise its position.
B
Bradley FitzgeraldAug 28, 2025
What to do if my EINHELL Water Pump does not pump water?
- C
  Cheryl ChristianAug 28, 2025
  If your EINHELL Water Pump isn't pumping water, it could be due to a couple of issues: * The intake sieve might be clogged. If so, clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
M
Marcus MarksSep 4, 2025
Why EINHELL GC-DP 5225 N has insufficient pumping rate?
- D
  Dustin MahoneySep 4, 2025
  An insufficient pumping rate in your EINHELL Water Pump can occur due to: * A clogged intake sieve. Clean the intake sieve. * Reduced performance caused by heavily contaminated and abrasive water impurities. Clean the equipment and replace any worn parts.

EINHELL GC-DP 5225 N Specifications

General

Power	520 W
Max Delivery Height	25 m
Max Suction Depth/Immersion Depth	7 m
Water Temperature	up to 35 °C
Power Cord	10 m
Voltage	230 V
Frequency	50 Hz
Min Suction Level	20 cm
Hose Connection	1 inch
Inlet/Outlet Diameter	1 inch