Why EINHELL GC-DW 1000 N Water Pump is not pumping?
If your EINHELL Water Pump isn't pumping water, it could be due to a couple of reasons. The intake sieve might be clogged, so try cleaning it with a water jet. Alternatively, the discharge hose might be kinked; make sure to unkink the hose.
What to do if my EINHELL GC-DW 1000 N switches off after briefly running?
If your EINHELL Water Pump switches off shortly after starting, there are a couple of potential reasons. First, excessive water contamination may be triggering the motor circuit-breaker; in this case, unplug the power and clean the equipment and shaft. Second, the water temperature might be too high, also tripping the circuit-breaker. Make sure the water temperature doesn't exceed 35°C.
Why is the pumping rate of my EINHELL GC-DW 1000 N insufficient?
An insufficient pumping rate in your EINHELL Water Pump can be caused by two main issues. The intake sieve may be clogged, requiring cleaning. Additionally, heavily contaminated or abrasive water impurities can reduce performance. In this case, clean the equipment and replace any worn parts.
How to troubleshoot an EINHELL GC-DW 1000 N Water Pump that does not start?
If your EINHELL Water Pump isn't starting, the most likely cause is that the power supply isn't connected. Check the power supply to ensure it is properly connected.
General| Power | 1000 W |
|---|---|
| Max Delivery Rate | 10000 L/h |
| Max. delivery rate | 10000 L/h |
| Max. delivery height | 45 m |
| Weight | 10.5 kg |
| Max. water temperature | 35 °C |
| Hose connection | 1 1/4" (42 mm) IG |
| Power cable | 10 m |
| Max Flow Rate | 10000 L/h |
| Power Consumption | 1000 W |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Cable Length | 10 m |
To Next Page