EINHELL GC-DP 9040 N - User Manual

Questions and Answers

R
Ronald MartinAug 11, 2025
Why does my EINHELL GC-DP 9040 N Water Pump switch off after briefly running?
- M
  Mary JohnsonAug 11, 2025
  Your EINHELL Water Pump might be switching off shortly after starting due to a couple of reasons: * The motor circuit-breaker might be tripping because of excessive water contamination. If this is the case, unplug the power and clean the equipment and shaft. * Alternatively, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Ensure that the water temperature does not exceed 35 °C.
A
Amanda HarrisonAug 17, 2025
What to do if my EINHELL Water Pump does not pump water?
- J
  Jessica GreenAug 17, 2025
  If your EINHELL Water Pump isn't pumping water, it could be due to a couple of issues: * The intake sieve might be clogged. If so, clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
J
Jeremy HensonAug 23, 2025
What to do if my EINHELL GC-DP 9040 N does not start?
- P
  Peter GrimesAug 23, 2025
  If your EINHELL Water Pump doesn't start, there are a couple of things you can check: * First, make sure the power supply is properly connected. * Second, check the floating switch. If it's not triggering, raise its position.
O
Oscar AllenAug 28, 2025
Why EINHELL GC-DP 9040 N has insufficient pumping rate?
- M
  marcusboyleAug 28, 2025
  An insufficient pumping rate in your EINHELL Water Pump can occur due to: * A clogged intake sieve. Clean the intake sieve. * Reduced performance caused by heavily contaminated and abrasive water impurities. Clean the equipment and replace any worn parts.
C
Courtney ThompsonSep 4, 2025
What to do if my EINHELL Water Pump does not cut out?
- M
  Morgan ClineSep 4, 2025
  If your EINHELL Water Pump isn't cutting out, it might be because the floating switch can't sink. Ensure the equipment is correctly placed on the shaft bottom.

EINHELL GC-DP 9040 N Specifications

General

Power	900 W
Max Flow Rate	9000 l/h
Max Head	40 m
Suction Height	8 m
Weight	5.2 kg
Max. delivery capacity	9000 l/h
Max. delivery height	40 m
Max. immersion depth	7 m
Water temperature	up to 35 °C
Power Consumption	900 W
Voltage	230 V
Frequency	50 Hz
Power cord	10 m