EINHELL GC-DP 7835 - User Manual

Questions and Answers

S
susanlewisJul 30, 2025
Why does my EINHELL Water Pump switch off after briefly running?
- J
  James HopkinsJul 30, 2025
  Your EINHELL Water Pump might be switching off shortly after starting due to a couple of reasons: * The motor circuit-breaker might be tripping because of excessive water contamination. If this is the case, unplug the power and clean the equipment and shaft. * Alternatively, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Ensure that the water temperature does not exceed 35 °C.
M
Melinda DunlapAug 4, 2025
What to do if my EINHELL GC-DP 7835 does not cut out?
- A
  Amy CarrollAug 4, 2025
  If your EINHELL Water Pump isn't cutting out, it might be because the floating switch can't sink. Ensure the equipment is correctly placed on the shaft bottom.
J
Justin BellAug 10, 2025
What to do if my EINHELL GC-DP 7835 Water Pump does not start?
- T
  tammyadamsAug 10, 2025
  If your EINHELL Water Pump doesn't start, there are a couple of things you can check: * First, make sure the power supply is properly connected. * Second, check the floating switch. If it's not triggering, raise its position.
M
Michael SalazarAug 16, 2025
What to do if my EINHELL GC-DP 7835 does not pump water?
- R
  Robert SerranoAug 17, 2025
  If your EINHELL Water Pump isn't pumping water, it could be due to a couple of issues: * The intake sieve might be clogged. If so, clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
V
Victor RomeroAug 23, 2025
Why EINHELL GC-DP 7835 has insufficient pumping rate?
- J
  Jacqueline WilliamsAug 23, 2025
  An insufficient pumping rate in your EINHELL Water Pump can occur due to: * A clogged intake sieve. Clean the intake sieve. * Reduced performance caused by heavily contaminated and abrasive water impurities. Clean the equipment and replace any worn parts.

Summary

Safety Regulations

Layout and Items Supplied

Layout Diagram

Diagram showing the main parts of the pump.

Items Supplied Check

Details on the items included in the delivery and how to check them.

Proper Use

Technical Data

Before Starting the Equipment

Installation Guidelines

Guidance on pump installation, including pipe diameter and special conditions.

Mains Connection

Operation

Setting the On;Off Switching Point

How to adjust the floating switch for automatic operation.

Manual Operation Mode

Using the pump continuously under supervision.

Replacing the Power Cable

Cleaning, Maintenance and Ordering of Spare Parts

Cleaning the Paddle Wheel

Procedure for cleaning the paddle wheel if deposits collect.

Maintenance

Note that no internal maintenance is required for the pump.

Ordering Replacement Parts

Information needed when requesting spare parts.

Disposal and Recycling

Storage

EINHELL GC-DP 7835 Specifications

General

Cord length	10 m
Product color	Black, Red
Housing material	Plastic
Carrying handle(s)	Yes
Motor power	- hp
Pumping capacity	15700 l/h
Maximum delivery height	8 m
Depth of immersion (max)	7 m
Solid particles size (max)	35 mm
Maximum input water temperature	35 °C
AC input voltage	230 V
AC input frequency	50 Hz
Quantity	1