EINHELL GC-DP 7835 User Manual

GB
- 14 -
11. Troubleshooting guide
Faults Cause Remedy
The equipment
does not start
- Power supply not connected
- Floating switch does trigger
- Check power supply
- Raise position of fl oating switch
The equipment
does not pump
- Intake sieve clogged
- Discharge hose kinked
- Clean intake sieve with water jet
- Unkink the hose
The equipment
does not cut out
- Floating switch cannot sink - Place equipment correctly on shaft
bottom
Insuffi cient pumping
rate
- Intake sieve clogged
- Performance reduced due to heavi-
ly contaminated and abrasive water
impurities
- Clean intake sieve
- Clean equipment and replace wear
parts
The equipment swit-
ches off after briefl y
running
- Motor circuit-breaker switches the
equipment off due to excessive wa-
ter contamination
- Water temperature too high; motor
circuit-breaker switches the equip-
ment off
- Unplug power plug and clean
equipment and shaft
- Ensure that maximum permissible
water temperature (35 °C) is not
exceeded
Anl_SA_GC_DP_7835_SPK8.indb 14Anl_SA_GC_DP_7835_SPK8.indb 14 28.04.16 09:3928.04.16 09:39

EINHELL GC-DP 7835 Specifications

General

Cord length	10 m
Product color	Black, Red
Housing material	Plastic
Carrying handle(s)	Yes
Motor power	- hp
Pumping capacity	15700 l/h
Maximum delivery height	8 m
Depth of immersion (max)	7 m
Solid particles size (max)	35 mm
Maximum input water temperature	35 °C
AC input voltage	230 V
AC input frequency	50 Hz
Quantity	1

Weight and Dimensions

Weight	5200 g
Package depth	220 mm
Package width	180 mm
Package height	380 mm
Package weight	5700 g