EINHELL GC-DP 3730 User Manual

GB
- 9 -
11. Troubleshooting guide
Faults Cause Remedy
The equipment
does not start
- Power supply not connected
- Floating switch does trigger
- Check power supply
- Raise position of fl oating switch
The equipment
does not pump
- Intake sieve clogged
- Discharge hose kinked
- Clean intake sieve with water jet
- Unkink the hose
The equipment
does not cut out
- Floating switch cannot sink - Place equipment correctly on shaft
bottom
Insuffi cient pumping
rate
- Intake sieve clogged
- Performance reduced due to heavi-
ly contaminated and abrasive water
impurities
- Clean intake sieve
- Clean equipment and replace wear
parts
The equipment swit-
ches off after briefl y
running
- Motor circuit-breaker switches the
equipment off due to excessive wa-
ter contamination
- Water temperature too high; motor
circuit-breaker switches the equip-
ment off
- Unplug power plug and clean
equipment and shaft
- Ensure that maximum permissible
water temperature (35 °C) is not
exceeded
Anl_GC_DP_3730_SPK7.indb 9Anl_GC_DP_3730_SPK7.indb 9 12.02.2019 09:58:4112.02.2019 09:58:41

EINHELL GC-DP 3730 Specifications

General

Type	Velocity pump
Proper use	Drainage, Water purification
Product color	Black, Red
Assembly required	No
Suitable for indoor use	-
Suitable for outdoor use	Yes
Flow rate	9000 l/h
Grain size	30 mm
Maximum suction height	5 m
Maximum operating pressure	- bar
Maximum input water temperature	35 °C
AC input voltage	230 V
Power cable type	H05RN-F
Power source type	AC
AC input frequency	50 Hz
Package weight	5150 g
Quantity per pack	1 pc(s)
Cable length	10 m

Weight and Dimensions

Depth	220 mm
Width	180 mm
Height	400 mm
Weight	4300 g