EasyManua.ls Logo

EINHELL GC-SP 2768 - User Manual

EINHELL GC-SP 2768
96 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
GC-SP 2768
Art.-Nr.: 41.704.42 I.-Nr.: 11028
9
D Originalbetriebsanleitung
Tauchpumpe
GB Original operating instructions
Submersible pump
F Instructions d)origine
Pompe submersible
I Istruzioni per l)uso originali
Pompa sommersa
S Original-bruksanvisning
Dränkbar pump
NL Originele handleiding
Dompelpomp
E Manual de instrucciones original
Bomba sumergible
FIN Alkuperäiskäyttöohje
Uppopumppu
SLO Originalna navodila za uporabo
Potopna rpalka
GR

Table of Contents

Questions and Answers

  • A
    Abigail HaynesAug 10, 2025
    Why does my EINHELL GC-SP 2768 Water Pump switch off after briefly running?
    • K
      Kathleen GriffinAug 10, 2025
      Your EINHELL Water Pump might be switching off shortly after starting due to a couple of reasons: * The motor circuit-breaker might be tripping because of excessive water contamination. If this is the case, unplug the power and clean the equipment and shaft. * Alternatively, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Ensure that the water temperature does not exceed 35 °C.
  • T
    Tracy GravesAug 16, 2025
    What to do if my EINHELL Water Pump does not pump water?
    • L
      Linda FranklinAug 16, 2025
      If your EINHELL Water Pump isn't pumping water, it could be due to a couple of issues: * The intake sieve might be clogged. If so, clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
  • J
    Jesus PayneAug 22, 2025
    What to do if my EINHELL GC-SP 2768 does not start?
    • A
      Angela HuberAug 22, 2025
      If your EINHELL Water Pump doesn't start, there are a couple of things you can check: * First, make sure the power supply is properly connected. * Second, check the floating switch. If it's not triggering, raise its position.
  • W
    Wendy ValdezAug 28, 2025
    Why EINHELL GC-SP 2768 has insufficient pumping rate?
    • K
      Kelly SmithAug 28, 2025
      An insufficient pumping rate in your EINHELL Water Pump can occur due to: * A clogged intake sieve. Clean the intake sieve. * Reduced performance caused by heavily contaminated and abrasive water impurities. Clean the equipment and replace any worn parts.
  • V
    Vickie ValenciaSep 3, 2025
    What to do if my EINHELL Water Pump does not cut out?
    • K
      kelleydakotaSep 3, 2025
      If your EINHELL Water Pump isn't cutting out, it might be because the floating switch can't sink. Ensure the equipment is correctly placed on the shaft bottom.

EINHELL GC-SP 2768 Specifications

General IconGeneral
Max Delivery Rate6000 l/h
Max Delivery Height45 m
Max Suction Depth8 m
Weight5.5 kg
Max Water Temperature35 °C
Voltage230 V
Frequency50 Hz
Max Immersion Depth7 m
Power Cord10 m

Related product manuals