EINHELL GC-SP 3580 LL

Questions and Answers

A
Allison JonesAug 10, 2025
Why does my EINHELL GC-SP 3580 LL switch off after briefly running?
- T
  thompsonamberAug 11, 2025
  Your EINHELL Water Pump might be switching off shortly after starting due to a couple of reasons: * The motor circuit-breaker might be tripping because of excessive water contamination. If this is the case, unplug the power and clean the equipment and shaft. * Alternatively, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Ensure that the water temperature does not exceed 35 °C.
N
nmccallAug 16, 2025
What to do if my EINHELL GC-SP 3580 LL Water Pump does not start?
- Z
  zpattersonAug 16, 2025
  If your EINHELL Water Pump doesn't start, there are a couple of things you can check: * First, make sure the power supply is properly connected. * Second, check the floating switch. If it's not triggering, raise its position.
D
Dr. Juan CherryAug 22, 2025
What to do if my EINHELL Water Pump does not pump water?
- D
  David JacobsAug 22, 2025
  If your EINHELL Water Pump isn't pumping water, it could be due to a couple of issues: * The intake sieve might be clogged. If so, clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
W
whitney35Aug 28, 2025
Why EINHELL GC-SP 3580 LL has insufficient pumping rate?
- A
  Andrew CummingsAug 28, 2025
  An insufficient pumping rate in your EINHELL Water Pump can occur due to: * A clogged intake sieve. Clean the intake sieve. * Reduced performance caused by heavily contaminated and abrasive water impurities. Clean the equipment and replace any worn parts.
S
shane09Sep 3, 2025
What to do if my EINHELL GC-SP 3580 LL Water Pump does not cut out?
- M
  Mary FloresSep 3, 2025
  If your EINHELL Water Pump isn't cutting out, it might be because the floating switch can't sink. Ensure the equipment is correctly placed on the shaft bottom.

EINHELL GC-SP 3580 LL Specifications

General

Power	350 W
Max Flow Rate	8000 L/h
Max Delivery Height	7.5 m
Max Immersion Depth	7 m
Max Water Temperature	35 °C
Max Size of Foreign Particles	5 mm
Residual Water Level	1 mm
Power Cable Length	10 m
Voltage	230 V
Frequency	50 Hz
Protection Class	IPX8