How to troubleshoot EINHELL GC-SP 5511 IF that does not start?
If your EINHELL Water Pump isn't starting, there are a couple of things to check: * First, make sure the power supply is properly connected. * Second, the floating switch might not be triggering. In this case, try cleaning the switch unit.
What to do if EINHELL Water Pump does not pump?
If your EINHELL Water Pump isn't pumping water, consider these potential causes: * The intake sieve might be clogged. Clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
Why EINHELL GC-SP 5511 IF switches off after briefly running?
If your EINHELL Water Pump switches off soon after starting, it could be due to: * Excessive water contamination causing the motor circuit-breaker to activate. Unplug the pump and clean the equipment and shaft. * The water temperature might be too high, also tripping the motor circuit-breaker. Ensure the water temperature doesn't exceed 35 °C.
Why EINHELL Water Pump has insufficient pumping rate?
If your EINHELL Water Pump has an insufficient pumping rate: * Check the intake sieve for clogs and clean it. * Also, heavily contaminated water with abrasive impurities can reduce performance. Clean the equipment and replace any worn parts.
What to do if EINHELL GC-SP 5511 IF Water Pump does not cut out?
If your EINHELL Water Pump does not cut out, the floating switch might be unable to sink. Try cleaning the switch unit.
General| Brand | EINHELL |
|---|---|
| Model | GC-SP 5511 IF |
| Category | Water Pump |
| Language | English |
To Next Page