How to fix inadequate delivery rate in my EINHELL GC-WW 6538 set?
If your EINHELL Water Pump's delivery rate is inadequate, check the following: * Ensure that the suction height is not too high. * Clean the strainer if it is dirty. * If the water level is falling rapidly, place the suction hose at a deeper level. * If contaminants diminish pump performance, clean the pump and replace any worn parts.
Why won't my EINHELL GC-WW 6538 set Water Pump motor start up?
If the motor of your EINHELL Water Pump fails to start, check for these potential causes: * Verify that there is mains voltage; if not, check the voltage. * The pump rotor may be blocked. If so, dismantle and clean the pump.
What to do if thermostat switches EINHELL GC-WW 6538 set off?
If the thermostat is switching your EINHELL Water Pump off, it could be due to: * An overloaded motor. You can address this by dismantling and cleaning the pump. * Excessive friction caused by foreign substances. Prevent this by filtering out foreign substances.
What to do if my EINHELL GC-WW 6538 set has no intake?
If your EINHELL Water Pump isn't taking in water, consider these possibilities: * Ensure the intake valve is fully immersed in water. * Fill water into the intake if the pump chamber lacks a water connection. * Check that the intake line is airtight to prevent air leaks. * Clean the intake valve if it's leaking or the strainer if it's blocked. * Verify that the suction height doesn't exceed the maximum limit.
General| Power | 650 W |
|---|---|
| Max Flow Rate | 3800 L/h |
| Max Suction Depth | 8 m |
| Max Water Temperature | 35 °C |
| Suction Connection | 1 inch |
| Pressure Connection | 1 inch |
| Power Cable | 1.5 m |
| Pressure Switch | Yes |
| Manometer | Yes |
| Thermal Protection | Yes |
| Water Drain Plug | Yes |
| Pump Housing | Plastic |
| Hose Connection | 1 |
To Next Page