What to do if EINHELL GC-WW 6538 Water Pump has inadequate delivery rate?
If the EINHELL Water Pump has an inadequate delivery rate, check the following: 1. Ensure that the suction height is not too high. 2. Check if the strainer is dirty and clean it if necessary. 3. If the water level is falling rapidly, place the suction hose at a deeper level. 4. If contaminants diminish pump performance, clean the pump and replace any worn parts.
Why EINHELL GC-WW 6538 has no intake?
If the EINHELL Water Pump has no intake, consider these potential causes: * The intake valve is not in the water: Immerse the intake valve in water. * The pump chamber lacks a water connection: Fill water into the intake. * There is air in the intake line: Ensure the intake line is airtight. * The intake valve leaks: Clean the intake valve. * The strainer is blocked: Clean the strainer. * The maximum suction height is exceeded: Check the suction height.
Why EINHELL GC-WW 6538 motor fails to start up?
If the EINHELL Water Pump motor doesn't start, first check if there is mains voltage. If there isn't, ensure the pump is properly connected to a power source. If voltage is present, the pump rotor may be blocked. In this case, dismantle and clean the pump.
What to do if thermostat switches EINHELL GC-WW 6538 off?
If the thermostat switches the EINHELL Water Pump off, it could be due to the motor being overloaded. Dismantle and clean the pump to resolve this. Alternatively, high friction caused by foreign substances could be the cause. Prevent the intake of foreign substances by using a filter.
Adhere to safety regulations to prevent electric shock, fire, or serious injury.
Diagram and list of components for the home waterworks.
Check for completeness of parts upon delivery.
Connect suction hose with intake/non-return valve.
Connect discharge hose and open valves.
Connect to 220-240V socket with earthing contact.
Regular checks and maintenance for longevity.
Provide specific details for ordering correct parts.
Confirms product compliance with relevant EU directives and norms.
General| Flow rate | 3800 l/h |
|---|---|
| Maximum suction height | 8 m |
| Maximum delivery height | 36 m |
| Maximum operating pressure | 3.6 bar |
| Maximum input water temperature | 35 °C |
| Proper use | Garden |
| Product color | Black, Red |
| AC input voltage | 220-240 V |
| Power cable type | H07RN-F |
| Power source type | AC |
| AC input frequency | 50 Hz |
| International Protection (IP) code | IPX4 |
| Cable length | 1.4 m |
| Suction port | 1\ |
| Package depth | 535 mm |
| Package width | 305 mm |
| Package height | 526 mm |
| Package weight | 12130 g |
Weight and Dimensions| Weight | 10480 g |
|---|
To Next Page