Check the tension by pressing the belt (46). The
amount of play should be 15-20 mm.
15.3 Cleaning and maintenance
Clean dust off the drive gear unit of the
thicknessing plane with a brush or compressed air.
Lubricate all clamping points and chains at regular
intervals with a few drops of engine oil.
Keep the belt (46) free of oil and grease at the
same time, however.
Clean chips and dust off the spindles on the
thicknessing table at regular intervals and lubricate
them with a little oil. Keep the infeed table (13), the
planing table
(14) and the thicknessing table (42) free of chips.
Improve the smooth running of the tables by
applying lubricant at regular intervals.
15.4 Ordering replacement parts
Please provide the following information on
all orders for spare parts:
n Model/type of machine
n Article number of the machine
n ID number of the machine
n Number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
16. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
25
To Next Page
Loading...
Need help?
General
