EKKO EB20E - Maintenance, Recharging and Replacement of the Accumulator

16
9.4Maintenance, Recharging and Replacement of the accumulator
The truck must be parked in a safe location before any operation on the accumulator.
9.4.1 Maintenance Technician
Brake
1.1
Check the air gap of the electromagnetic brake
●
Electric
system
2.1
Check the function of operation switch, display equipment
and component
●
2.2
Check alarm systems and safety devices
●
2.3
Check the cable for damage. Whether the terminal is firm.
●
2.4
Check the function of micro switch setting
●
2.5
Check the controller and the EPS controller
●
2.6
Cable and motor fixation
Cable and motor fixation

●
Power
3.1
Check battery
●
3.2
Check the charging connector for battery
●
3.3
Check whether the connection of the battery cable is tight,
and smear the electrode with grease if necessary
●
Driving
system
4.1
Check the gearbox for noise
●
4.2
Check the driving mechanism and grease, check the reset
function of the operating handle
●
4.3
Check the drive wheels and bearing wheel for wear and
damage
●
4.4
Check wheel bearings and fixtures
●
Massive
structure
5.1
Check the frame for damage
●
5.2
Check the label for completeness
●
5.3
Check the fixation status of lifting mast
●
The
hydraulic
system
6.1
Check the hydraulic system function
●
6.2
Check that hoses, pipes, and joints are tight and that seals
are not damaged
●
6.3
Check cylinder and piston for damage, seal and fixation
●
6.4
Check load chain Settings and re-tighten if necessary
●
6.5
Visually inspect mast roller and inspect roller surface for
wear
●
6.6
Inspect cargo fork and load parts for wear
●
6.7
Check oil level
●
6.8
Renewed hydraulic oil
●