EKO MP-11 - Page 28

EKO INSTRUMENTS CO., LTD. I-V Curve Checker MP-11 Instruction Manual Ver.7
Pg. 27
CASE 5
Using the Measurement Data
from PC on MP-11 Main Unit
Measurement Item
Measurement Condition
N/A
 Comparing the measured data at the site against the past measured data.
Required Items
Configuration Image
A. MP-11 Main Unit
B. Battery Receptacle Box or
AC Adapter (1.8m)
C. USB Cable (2m)
D. PC Installed with MP-11
Software
Procedure
Reference Sections
1
Connect MP-11 Main Unit to PC with USB cable.
5-3
2
Turn the MP-11 Main Unit power ON。
8-2
3
Turn ON the PC and startup the MP-11 I-V Checker Software
9-3
4
Setup the communication port between the MP-11 Main Unit and the PC
9-3
5
Upload the measurement data to the MP-11 Main Unit.
9-3
6
Verify the uploaded data on the MP-11 Main Unit
9-3
7
Exit the MP-11 I-V Checker Software.
9-3
8
Turn the MP-11 Main Unit power OFF.
8-2
9
Disconnect the MP-11 Main Unit from the PC.
5-3
10
Shutdown the PC
-
A
B
C
D