6
Step 6 Fixing pump
1. After confirming no leakage situation, you can start fixing pump.
2. There are four equidistant holes on both top and bottom sides for two
steadies. You can freely choose which direction you want to fix. Besides,
you can add pad to strengthen the shock-absorbing effect.
3. After selecting the fixed mode that you like, assemble mountings, then fix
in the place that you make selection.
Annotation: Exhausting / Bleeding
Placing tank upon pump, turn on the power for 1 minute then turn off the
power for 1 minute, too. This action should last 5 minutes.
This will help bleeding the small air bubbles from your watercooling system.
EKWB d.o.o., Pot za Brdom 100, 1000 Ljubljana, Slovenia, EU
info@ekwaterblocks.com
www.ekwaterblocks.com
To Previous Page
Loading...
