Need help?Do you have a question about the ELAC Muro Series and is the answer not in the manual?
Read and follow safety instructions; keep them safe; check for damage before use.
Connect according to the manual; use spikes/anti-slip feet for leveling and stability.
Install on a level surface, avoid direct sun, humidity, vibrations, extreme temperatures, CRT TVs, magnetic cards.
Ensure stability to prevent severe injury; spikes and tape can enhance stability.
Avoid extreme overload at high volume to prevent component damage.
Do not open cabinet; servicing by qualified personnel only; risks of electric shock.
Replace blown fuse with the correct type and rating as shown on the rear.
Clean with soft cloth or dust brush; avoid chemical agents.
Continuous high volume may cause hearing damage; listen responsibly.
Dispose of packaging and product responsibly according to local legislation.
Connect only to specified voltages; avoid plug adapters to prevent warranty voiding.
ELAC's commitment to quality and sound since 1926.
Avoid damage; unbox carefully; turn off equipment before connecting cables.
Explains ELAC's amplifier technology for power reserves and low distortion.
Line level connection for pre-amp/AV receiver.
Used for pairing wireless audio receiver and factory reset.
For updating subwoofer firmware, not for normal operation.
Shows operational status, pairing mode, searching, or reset.
Standard IEC power jack for connecting the power cord.
Connect via RCA cable from AV Receiver/Pre-Amp to LFE IN.
Use optional wireless transmitter sold separately.
Out of the box settings: crossover 80Hz and volume 75%.
Uses DSP for adjustments; replaced analog controls.
Requires Bluetooth 4.0 device to download and use the ELAC SUB Control 2.0 app.
Best positions are front corner or side walls; use test discs for optimum location.
Options include vertical on floor, horizontal on floor, or wall mounting.
3 years on cabinet/driver, 1 year on amplifier from purchase date.
Applies to home use only; not for modified, abused products, or defaced serial numbers.
Contact ELAC America for service; proof of purchase required.
Contact local dealer/distributor for claims outside North America.
To Next Page
General
