Need help?Do you have a question about the ELAC SUB1010 and is the answer not in the manual?
General| Type | Active Subwoofer |
|---|---|
| Driver/Woofer Size | 10 inches |
| Enclosure Type | Bass Reflex |
| Auto On/Off | Yes |
| Amplifier Power | 100 Watts |
| Crossover Frequency | 50 Hz - 150 Hz |
| Inputs | RCA line in |
| Phase Switch | 0° / 180° |
Read and follow all safety instructions. Keep them safe for future reference and observe all warnings on the speaker and manual.
Connect the speaker as per manual instructions. Use provided spikes/feet for leveling and ensure stability.
Install on a level surface. Avoid direct sunlight, humidity, extreme temperatures, and magnetic sources.
Avoid extreme overload from high volume. Do not open the cabinet; servicing must be by qualified personnel.
Replace blown fuses with the correct type. Clean with a soft cloth, avoiding chemicals that degrade rubber feet.
Continuous high volume may damage hearing. Dispose of the speaker environmentally according to local legislation.
Connect only to specified voltages listed on the cabinet. Avoid plug adapters to prevent irreversible damage.
Adjusts the subwoofer's output level to properly blend with the rest of your audio system.
Sets the crossover frequency or low-pass filter for the subwoofer, between 40 Hz and 150 Hz.
Allows inversion of the subwoofer's polarity (180 degrees) to match main speakers and improve blending.
Switch between 'On' (Always On), 'Off' (Always Off), or 'Auto' mode for automatic power management.
Connects the subwoofer to a pre-amp or AV receiver using RCA cables for line-level input.
Use the provided power cord to connect the subwoofer to an available AC outlet for power.
Indicates the subwoofer's status: green for 'On', red for 'Off' or 'Auto' inactivity.
Connect an RCA cable from the LFE/Subwoofer output on the AV Receiver/Pre-Amp to the Left RCA input.
Connect stereo RCA cables to Left/Right inputs; use a splitter if the pre-amp has only one pre-out.
To Next Page
