Need help?Do you have a question about the ELAC S10.2 and is the answer not in the manual?
General| AC input voltage | 100-240 V |
|---|---|
| Power source type | AC |
| AC input frequency | 50 - 60 Hz |
| Power consumption (standby) | 0.5 W |
| Subwoofer type | - |
| Low pass filter | Yes |
| Number of subwoofers | 1 |
| Subwoofer peak power | 200 W |
| Subwoofer driver diameter | 254 mm |
| Subwoofer frequency range | 35 - 150 Hz |
| Subwoofer crossover frequencies | 50 - 150 Hz |
| Subwoofer driver diameter (imperial) | 10 \ |
| Material | MDF |
| Product color | Gray |
| Country of origin | China |
Weight and Dimensions| Subwoofer width | 343 mm |
|---|---|
| Subwoofer weight | 13000 g |
Read and follow safety instructions, keep them safe, observe warnings, check for damage, and handle carefully.
Avoid overload, do not open for service, use correct fuses, clean gently, and listen responsibly to protect hearing.
Controls for subwoofer level, crossover frequency, and phase adjustment to blend with the audio system.
Power switch modes (On, Off, Auto) and the power status indicator light for operational status.
Connect RCA from AV Receiver LFE/Subwoofer output to the subwoofer's Left RCA input.
To Next Page
