ELAC S10.2 User Manual

ELAC S10.2 Subwoofer | www.elac.com | Page 5
Connecting your Subwoofer
If you are connecting the subwoofer to an AV Receiver or Pre-Amp with a dedicated subwoofer or LFE output,
connect an RCA cable (not supplied) from the LFE/Subwoofer output on the AV Receiver/Pre-Amp to the Left
RCA input on the subwoofer (Fig 1).
If you are connecting the subwoofer to a stereo pre-amp or AV Receiver without a dedicated LFE/Subwoofer
output, connect a set of stereo RCA connectors to the left and right RCA inputs on the subwoofer. If you are
using a pre-amp with only one set of pre-outs, use a splitter for each output on the pre-amp and connect two
sets of stereo RCA cables to both the amplifier and to the subwoofer (Fig 2).

ELAC S10.2 Specifications

General

AC input voltage	100-240 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.5 W
Subwoofer type	-
Low pass filter	Yes
Number of subwoofers	1
Subwoofer peak power	200 W
Subwoofer driver diameter	254 mm
Subwoofer frequency range	35 - 150 Hz
Subwoofer crossover frequencies	50 - 150 Hz
Subwoofer driver diameter (imperial)	10 \
Material	MDF
Product color	Gray
Country of origin	China

Weight and Dimensions

Subwoofer width	343 mm
Subwoofer weight	13000 g