Need help?Do you have a question about the ELAC IW-S10EQ and is the answer not in the manual?
General| Type | In-wall subwoofer |
|---|---|
| Driver Size | 10 inches |
| Impedance | 8 ohms |
| Enclosure Type | Sealed |
| Frequency Response | 28 Hz - 150 Hz |
| Amplifier Power | 200 watts RMS |
| Peak Power Handling | 400W |
| Crossover Frequency | 50 Hz - 150 Hz |
| Finish | White |
| Inputs | RCA |
Read and follow all safety instructions and warnings for safe operation and future reference.
Connect and use the speaker as per manual instructions, ensuring proper alignment and stability for safe operation.
Only qualified personnel should service the loudspeaker due to high voltage risks. Do not open the cabinet.
Use appropriate gauge speaker wire and keep it away from electrical wires to minimize interference.
Cut hole in wall using template, trace, and make clean cuts. Secure speaker frame to hide rough edges.
Connect speaker wires to terminals, ensuring correct polarity. Ensure no exposed strands cause shorts.
Connect to AV Receiver/Pre-Amp with LFE/Subwoofer output using an RCA cable.
DSP allows adjustment of volume, phase, and calibration via a smartphone app.
Use Auto EQ and follow instructions for wall volume compensation and room equalization.
Use the app to find the amplifier's IP address, then access WEBGUI with 'admin'/'admin' for updates and settings.
To Next Page
