Elba EH-E9121ST(BK) - Troubleshooting

6
REPLACING THE LIGHT BULB
• Press the
button and press the button
to open the cover.
• Disconnect the power supply, slightly insert the
screwdriver at the edge of the LED light and pry
downward to take out the LED light (2W).
• Disconnect the connecting cable of LED light (2W) and replace a new LED light
unit (2W). Connect the power supply to ensure LED light (2W) is functioning.
※ The LED light bulb shall not be greater than 2W.
TROUBLESHOOTING
Malfunctions
Possible Root Cause
Checking
Weak Suction
The distance is too far between
the cooker hood and cooking
appliance
Lower down the cooker hood
installation height but within the safety
guideline
Strong convection due to too
much ventilation
Shut off some of the windows or doors
Cooker hood and light
not function
The power supply is not
connected
Check if the plug is well connected
and the power is on
Power cord is damaged Contact technicians for repair
Motor functions but
light not works
Light bulb is damaged
Replace a new light bulb (
2W)
Light works but motor
not function
The bearing may be damaged
Contact technicians for repair
The internal wires or motor
capacitor may be burnout
Vibration on the cooker
hood
The screw is loosen Tighten the screws
The cooker hood is
noisy
Exhaust pipe surface is distorted
Contact technicians to reinstall the
exhaust pipe