7
6. Temperature / Time Display Window
This window displays the adjusted temperature and time. When idle, it shows the room
temperature.
7. Sleep Mode Indicator
This indicator light will turn on when the sleep mode is activated. To activate the sleep mode,
press the Timer and Down button simultaneously (Refer Sleep Mode).
8. Water Full Indicator
This indicator light will turn on when the condensation water is full in the appliance. The
appliance may turn off momentarily until the water has been drained off from the outlet (Refer
Drainage Method).
9. High / Low Indicator
This indicator light will turn on when the corresponding fan speed is selected.
OPERATING INSTRUCTION
In Cooling Mode
When the set temperature is greater than the room temperature by 1ºC (1ºF), the
compressor will start operating.
When the set temperature is lower than the room temperature by 1ºC (1ºF), the
compressor will stop, only the fan remains operating.
In Sleep Mode
Press the Timer and Down button simultaneously and the sleep mode will be activated.
After operating for two hours, the set temperature will increase by 1ºC (1ºF) automatically.
After operating for four hours, the set temperature will further increase by 1ºC (1ºF).
The fan speed will be switched to Low automatically.
In Dehumidification (Dry) Mode
In Dry mode, if the room temperature ≥ 17ºC (62ºF), the compressor will start.
When the room temperature ≤ 15ºC (59ºF) the compressor shuts down.
When the room temperature rises to be ≥ 17ºC (62ºF), the compressor starts again.
There will be a 3-minute protection delay for the compressor.
In dehumidification mode, the fan is defaulted to run at low speed, and wind speed cannot
be adjusted. Temperature cannot be set.
In Fan Mode
In Fan mode, the fan runs on either Low speed or High speed.
The temperature setting is not available in this mode.
The room temperature will display between 10–35ºC (50-95ºF).
To Next Page
Loading...
