Elcometer 270 - English; Default Chapter; Table of Contents

Section
Page
1
Gauge Overview
en-2
2
Box Contents
en-3
3
Getting Started
en-3
3.1
Fitting the Batteries
en-3
3.2
Battery Condition
en-3
3.3
Switching On / Off
en-3
3.4
Selecting the Voltage
en-4
3.5
Calibration Test
en-4
4
Using the Elcometer 270
en-5
5
Spares & Accessories
en-6
6
Warranty Statement
en-7
7
Technical Specification
en-7
8
Legal Notices & Regulatory Information
en-7
For the avoidance of doubt, please refer to the original English language version.
Dimensions: Detector (without Wand): 210 x 42 x 37mm (8.3 x 1.7 x 1.5”)
Weight: Detector, Wand Assembly, Batteries & Connecting Cable: 610g (21oz)
A Material Safety Data Sheet for the Wetting Agent (Kodak Photo-Flo™) supplied as an accessory for the
Elcometer 270 is available to download via our website:
http://www.elcometer.com/images/stories/MSDS/elcometer_270_wetting_agent.pdf
© Elcometer Limited 2009 - 2016. All rights reserved. No part of this document may be reproduced, transmitted,
transcribed, stored (in a retrieval system or otherwise) or translated into any language, in any form or by any
means (electronic, mechanical, magnetic, optical, manual or otherwise) without the prior written permission of
Elcometer Limited.
CONTENTS
www.elcometer.com
en-1
R