Electcom PRO - Video Setup; Speaker Setup; Digital Setup

KEY:
Press ▲ ▼ to adjust the tone level.
BRIGHTNESS
CONTRAST
HUE
SATURATION
SHARPNESS
Use ▲ ▼ to adjust the corresponding value of the video output.
DOWN M IX LT/RT: When you play a disc that has logic effect, you can
choose LT/RT output.The disc information will be decoded and show better
effect.
STEREO: When 2ch output is selected, normal stereo signals may be
played from the L&R output socket.
OP MODE
LINE OUT: The input signals are linear compressed and the volume is
lower. You should rather choose LINE OUT setting at night.
RF REMOD: The volume is higher and adapt to daytime use.
DYNAMIC RANGE
When you choose LINE OUT mode, select DYNAMIC RANGE to adjust the
compression ratio and you can get different effects. When you adjust to
FULL, the compression ratio will be set to the lowest level. When adjust is
OFF, the compression ratio will be set to the lowest level.
DUAL MONO:
You can set the audio output mode for Left or Right channel. There are four
modes: STEREO, MONO L, MONO R, and MIX MONO.
8
4.Video Setup
5.Speaker Setup
6.Digital Setup