19
Servicing and Maintenance
1. This vehicle is designed for minimum maintenance. However it is recommended that an approved
Electric Mobility Dealer services your vehicle at least once a year. If the vehicle is used constantly we rec-
ommend a twice-yearly maintenance.
2. Ensure the engineer stamps this Handbook on completion for all servicing carried out on this vehicle.
Keep all receipts for servicing and repairs with this handbook. This may add value when selling the vehicle.
3.
When the vehicle is due for its annual service make sure you report any concerns you have,
preferably when you book the service (See points to look out for below).
4. On completion of the service, Always test the vehicle before the engineer leaves and make sure you
are satisfied with the work carried out.
Points to look out for:
• Are there any strange noises from the wheels or does the frame creak when going over rough ground?
• Are the batteries charging up correctly – is the full charge light coming on after charging?
• Is the steering tight or is it loose when tur
ning? Is there any play in the steering?
• Does the seat lock securely in position ? Does squeak when rotated ?
• Has anything come loose?
• Does the vehicle perform as well as it did when it was new?
• Are there noises or rattles that were not there before?
• Are there any signs of damage or cracking?
Engineer’s Checklist
Important Note for the Engineer
Enquire if the customer is satisfied with the product. Please report all points good or bad directly to:
Electric Mobility +(0)1460 258100 If you have any comments please include them.
Servicing is to be carried out by a trained and competent technician familiar with the 600 T and F Models.
• Initial diagnostic road test
• Wheel bearings wear and lubricate
• Wheel alignment and tracking
• Wear or damage to tyres or wheels
• Speed dial works correctly
• All Lights and horn function correctly
• Bodywork fixtur
es
• Frame for damage or cracks
• General corr
osion
• Damage to cables, connectors, cable gr
ommets etc.
• Throttle play and adjustment
• Battery box contacts & signs of corrosion
• Correct operation of the battery ammeter
• Steering bearing (adjust as required)
• Tiller adjustment – functioning , wear and damage
• Seat mounting for cracks or damage
• Revolving seat mechanism locates and locks
correctly
• Electric seat height adjustment (if fitted)
check correct function
• Handlebar alignment
• Motor brush wear
• Motor speed check
• Electromagnetic brake operation
• Fr
eewheel operation
• All operational contr
ols and lights work correctly
• Battery condition and charger operation
• Tighten all nuts & bolts
• Final road test
• Clean vehicle
• Customer road test
To Next Page
Loading...
