Armrest Adjustment
When getting seated on the scooter lift the armrest
up. When riding always have the armrest in the
down
position. Avoid pinching fingers as you lower
the
armrest. If you require more room in the width
of the
seat undo the wheel knobs at the rear of the
seat (Fig.7). Slide the armrests in or out to suit.
Tighten both wheel knobs to clamp. To ensure that
the u
ser is sitting centrally, the armrests should
always be adjusted to be equidistant from the
centre of the seat.
This allows easy access.
1. To operate, locate the release lever under
seat (Fig.9).
2. Pull the lever up and the seat will
allowing it to rotate.
3. Release the lever and the seat should
automatically, but always check it has.
Do not use this device if the scooter
is on a slope. Always check the seat is
the forward position before driving the scooter.
Warning! Never drive with the armrest up or
with the armrest knob loose.
The angle of the seat back is fixed however it
be folded to allow easy storage and handling. To
fold
the seat, hold it by the top edge and push
forward (Fig.8).
10
Rascal Vippi Scooter Owner’s Manual & Service Record
To Next Page
Loading...
