To lock the tiller (steering) during transport and
loading/unloading from a vehicle:
Make sure tiller is in a straight drive position,
with wheels facing directly forwards.
Transport Lock
The tiller can be folded down for transport and
storage. Take care when lowering the tiller not to
pinch your fingers at the base of the tiller. Once in
the folded position, the tiller can be locked in place
to avoid tiller movement during transport and/or
storage using the “Tiller Transport Lock” - see
Transport Lock
section of this manual for further
details.
Tiller Folding:
Rotate the wheel anti-
clockwise sufficiently for the
retaining serrations to allow the
stow with the tiller lowered (Fig.10 & 12).
so that it is in its lowest position.
Rotate the wheel clockwise and ensure that it is
tight and the retai
ning serrations are fully
engaged.
Tip:
The tiller can be adjusted to achieve a
comfortable driving position.
the Scooter
If you feel at all uncertain about getting in or out of
the scooter seek assistance.
Transferring into the Scooter
1.
Make sure that the scooter is on a level
surface, and it is not in Freewheel mode.
2. Make sure the brakes are engaged -
try to push
the scooter a little to verify that the brakes are
working.
3. Ensure that the Ignition Key is turned to OFF.
(The red LED on the dashboard will not be lit or
flashing).
4.
Ensure that the handlebar/tiller adjustment
and seat adjustments are fully tightened
any accessories are properly fitted and secured.
5. The seat should be facing forwards.
6. Adjust the handlebars/
wheels are facing forward.
7. Raise one armrest to make access easier.
11
Lift up on the yellow knob and then turn to the
central position and release
steering.
To unlock the steering/tiller, reverse the above
procedure.