ElectrIQ AIRFLEX15 - Page 11

Page 11 of 24
(7) to (9) FUNCTION INDICATORS
An LED will illuminate to show which mode the unit is currently in. This can be changed
between Dehumidify (7), Cooling (8) and Heating (9) using the Function Button (3)
(10) IR REMOTE SENSOR
Receives infra red signals from the supplied remote control
(11) to (14) FAN SPEED INDICATORS
An LED will illuminate to show which fan speed the unit is currently set to. This can be
changed between High (11), Medium (12), Auto (13) and Low(14) using the fan speed
button (6).
(15) LED DISPLAY
Shows the set temperature or timer settings while in normal operation. When the set
temperature or the timer is adjusted, the new setting is shown on the display.
 When the TEMP+ or TEMP- buttons are pressed, the display will show the desired
temperature currently set.
 When the [TIMER] button is pressed the number of hours remaining will be shown until
function is achieved or deactivated.
 In the dehumidification function, “dH”(or “HP” upside-down) is shown in the display.
The LED display is also used to show error codes should a fault occur
E1
The room temperature sensor is faulty or pcb circuit is short circuited.
E4
Water is full, need manual drainage
E2
The coil sensor is open or short circuited, but this should not affect the normal
operation.