Page 12 of 24
REMOTE CONTROL
MULTI PROTECTIVE FUNCTION
ANTI-FREEZE PROTECTION CONTROL:
When the ambient temperature is low while in Cooling Mode, the compressor and water
pump will stop working if the copper coil temperature is too low. When the copper coil
temperature increases, the protection will be stopped automatically. While in this mode “Df”
will be displayed on the unit.
WATER-FULL PROTECTION:
When the water level in the internal water tank is above the maximum level, the unit will
alert automatically and E4 will be displayed on the LED screen. Please discharge the water
from the water tank by following the instructions in the “Water Drainage” section.
COMPRESSOR PROTECTION
The compressor has overheat protection which may stop the compressor to prevent
damage. The compressor also has a 3 minute delay protection function which delays the
start of the compressor, to help protect the compressor against repeated loss of power.
Change between heating, cooling,
dehumidifying, fan and auto modes
To Next Page
Loading...
