Electro-Harmonix OCEANS 12 - Page 16

16
To toggle pre-reverb SEND/RETURN, power-cycle the Oceans 12 while
holding down the FUNCTION button. If the SEND/RETURN status was
previously post-reverb or OFF, it will now be pre-reverb. Similarly, if the
SEND/RETURN status was previously pre-reverb, it will now be turned
OFF.
To toggle post-reverb SEND/RETURN, power-cycle the Oceans 12 while
holding down the TAILS button. If the SEND/RETURN status was
previously pre-reverb or OFF, it will now be post-reverb. Similarly, if the
SEND/RETURN status was previously post-reverb, it will now be turned
OFF.
The SEND LVL is a global parameter that will not be tracked by presets.
The configuration (pre vs. post) of the Send/Return as well as its SEND
LVL, however, are remembered across power cycles.
Turning on the Send/Return FX Loop also disables the signal-splitting
stereo control of the FUNCTION button.
If the configuration of Send/Return FX Loop is pre-reverb , but nothing
is inserted into the R/RETURN jack, the FX Loop connection is shorted
and the send channel connects directly to the return for regular mono
operation.