ECHO –
MODE: Cycles through the tempo subdivisions of the current echo
time: quarter-note (Mode 1), dotted-eighth-note (Mode 2), and
eighth-note (Mode 3).
FEEDBACK: Controls the number of repeats of the delayed signal. As
this knob is turned clockwise, the number of repeats increases.
DELAY: Controls the delay time of the echoes. Turn this knob
clockwise to increase the delay time. Delay time ranges from 5
milliseconds to 1 second.
TREM –
MODE: Cycles through three LFO wave shapes: triangle (Mode 1),
square (Mode 2), and sine (Mode 3).
RATE: Sets the rate of the amplitude LFO, from 1Hz at fully counter-
clockwise to 256Hz to fully clockwise.
DEPTH: Sets the depth of the amplitude LFO. Turn this knob
clockwise to increase the depth, and counter-clockwise to decrease it.
MOD –
MODE: Cycles through three different modulations. In Mode 1, a
chorus is applied to the reverb. In Mode 2, flanging is applied to
achieve a classic EHX flerb. In Mode 3, the chorus and flerb from your
settings in Mode 1 and Mode 2, respectively, are mixed together and
applied to the reverb.
RATE: Sets the rate of the modulation. In Mode 3, RATE sets the
blend amount between chorus (fully counter-clockwise) and flerb
(fully clockwise).
DEPTH: Sets the depth or intensity of the modulation. In Mode 3,
DEPTH doesn’t control anything.
DYNA –
MODE: The mode button cycles through three dynamic algorithms
with non-linear outputs.
- In Mode 1, a swell algorithm is selected that suppresses note
attacks and fades-in their reverb tails. TIME behaves normally and
controls the reverb decay.
- In Mode 2, a noise gate is selected that opens the reverb sound
for only louder notes. TIME controls the length of time the gate
stays open once it’s been triggered.
To Next Page
Loading...
