Need help?Do you have a question about the Electro-Voice Dx38 and is the answer not in the manual?
General| AC voltage | 90-250 V AC (50-60 Hz) |
|---|---|
| Power consumption | 30 W maximum |
| Nominal input voltage | 1.55 V (+6 dBu) |
| Maximum input voltage | 24.5 V (+30 dBu) |
| Input impedance | 20 kΩ |
| Nominal output voltage | 1.55 V (+6 dBu) |
| Maximum output voltage | 8.7 V (+21 dBu) |
| Output impedance | <100 Ω |
| Minimum load impedance | 600 Ω |
| Frequency response | 20 Hz–20 kHz (-0.5 dB) |
| S/N ratio | >115 dB (typical) |
| THD without transformer | <0.01% (1 kHz) |
| THD with transformer | <0.05% (1 kHz) |
| A/D conversion | 24-bit; 128x oversampled; linear phase |
| D/A conversion | 24-bit; 128x oversampled; linear phase |
| Data format | 24-bit linear AD/DA conversion; 48-bit processing |
| Sample rate | 48 kHz |
| Display | 122 x 32 dots, graphic LCD display with LED backlight |
| 3 master delays | 2–900 ms |
| 4 channel delays | 0–900 ms |
| Delay increment | 21 µsec |
Weight and Dimensions| Dimensions | 1.72" (43.6 mm) x 19.0" (483 mm) x 14.8" (375 mm) hwd |
|---|---|
| Weight | 11 lbs (5 kg) |
Detailed overview of the Electro-Voice Dx 38's advanced digital sound system processor capabilities.
Description of the controls and indicators located on the front panel of the Dx 38 unit.
Description of the connections and ports located on the rear panel of the Dx 38 unit.
Details on setting up balanced audio connections for optimal performance with the Dx 38.
Guidance on establishing unbalanced audio connections for the Dx 38 unit.
Guidance on setting input and output levels for optimal gain structure and signal-to-noise ratio.
How to adjust crossover frequencies for different output channels using the Dx 38's editing functions.
Instructions for using the equalizer settings to match the Dx 38 to specific loudspeaker systems.
How to configure compressor and limiter parameters for system protection and peak control.
Details of the Stereo 2-Way crossover configuration, including input/output routing.
Configuration for a 2-way stereo system with a mono sub and additional full-range output.
Description of the 3-way monaural crossover with a full-range output configuration.
Configuration for a 3-way system with a summed mono sub and a full-range output.
Details of a 3-way configuration using an independent sub-channel and a full-range output.
Description of the monaural 4-way frequency crossover configuration.
Configuration for full-range operation with two inputs and four outputs.
Step-by-step guide to selecting and activating factory or user-defined programs on the Dx 38.
To Next Page
