Need help?Do you have a question about the Electro-Voice MTH-4/64B and is the answer not in the manual?
General| Impedance | 8 Ohms |
|---|---|
| LF Transducer | 4 x 4" (100 mm) cone |
| Grill | Steel |
| Driver | 4 x 4" (100 mm) cone |
| Power Handling (Continuous) | 64 W |
Measured on axis in the farfield in an anechoic environment using a swept sine wave.
Details the four 10-inch midbass drivers and compression drivers for MF/HF bands.
Specifies nominal and minimum impedance for MB, MF, and HF sections.
Shows second and third harmonic distortion levels at 120 dB SPL.
Enables smaller, lighter arrays with high acoustic output and low distortion.
Constructed of birch plywood, available with carpet or paint finish.
Details ANSI/EIA 426-A ratings for midbass, mid-frequency, and high-frequency sections.
Recommends crossover frequencies and use of the Dx34 digital unit.
Ideal for concert-sound touring and permanent installations requiring high SPL.
Overview of the two-point flying system for flexible array design and quick assembly.
Instructions for accessing drivers, replacement, and available service parts.
To Next Page