Electro-Voice MTL-2 User Manual

Frequency response measured on axis, swept one-third-octave pink noise.

Details long-term average and short-term power handling capacity per EIA RS-426A.

SPL at 1 meter for indicated input power, band-limited pink-noise signal.

Dispersion angle and directivity index/factor for specified octave bands.

Harmonic distortion components at 0.1 and full power input.

Specifies the two drivers used in the enclosure.

Materials, finish, hanging system, dimensions, and weight.

Details the patented manifold technology for low-frequency sound reinforcement.

Optimized for complementing MTH-2 high-frequency cabinets for a full-range system.

Achieved using dedicated low EQ module in XEQ-3 crossover.

Illustrates directional characteristics using polar responses and beamwidth data.

Inherent reduction compared to conventional vented enclosures.

Explanation of random noise input, high/low frequency energy, and peak values.

Details adherence to the EIA test spectrum for 8 hours.

Recommended for maximizing performance with response correction and subpassband protection.

Essential for preventing cone excursion and damage below enclosure tuning frequency.

Governed by thermal capacity and linear cone-excursion ability.

Using multiple systems increases acoustic output, e.g., 6-dB increase for two systems.

Discusses placement on floor, floor-wall junction, and corner for acoustic benefits.

Can be operated away from boundaries, especially with multiple systems.

Equipped with two Neutrik Speakon NL4MPR connectors for input and output.

Details the pin assignments for the two DL18MT drivers.

Conceived for flying with two-point flying hardware for flexibility.

Recommends removing or firmly securing the grille for permanent overhead installation.

Five-year guarantee against defects in workmanship and materials.

Provides the service and repair address for the product.