Electro-Voice SxA Series - Two-Way System Connection Diagrams; Microphone and Line Input Setup

use the SxA two-way system for various applications:
* Plug a microphone into the microphone input connector (See Figure 3), ]t will only accept
low-impedance dynamic microphones terminated with a standard 3-pin XLR-type
connector. Turn the gain control clockwise until the signal present LED stays on w'ith the
input signal at normal operational level. Adjust the master gain control to the desired
overall output level.
* Plug a line input into either the Vi-inch or the 3-pin XLR-type input connector. Examples
of line input sources are mixer outputs, CD/D YD players, cassette decks, VCRs,
electronic keyboards, computer sound cards, etc. The Vi- inch input is in the center of the
XLR. connector and can accept unbalanced or balanced linevS (TRS L-inch), The line input
level required to drive the unit to full pcwer is from -- 12 dBu to 0 dBu. The system's
master gain control regulates the overall output level of the system.
Figure 3:
Microphone input Connections
& Connections To Additionai Systems
ELSC'TRO-VOICE® Owrier's; Manual
6