Electro-Voice SxA Series - SxA180 Woofer System Setup; Initial Woofer Setup and Connection; SxA180 Rear Panel Identification

Woofer
To get your woofer system into operation as quiokiy as possible, please observe the following
steps and precautions:
ft
Plug the 3-terminai lEC 16-gauge ac cable into a grounded line receptacle. Extension
cords can be used as necessary but make sure that they are the Swonductor type that are
14 gauge or greater, and are properly grounded to avoid electrical hazards and
extraneous noise.
Turn on the power switch and ensure that the system is receiving pow'er by monitoring the
status LED power on. MAKE SURE THAT THE LEVEL CONTROLS APvE TURNED
DO WN TO AVOID I'RANSIENTS OR UNEXPECTED LOUD SOUND.
* Attach a 3-pin XLR cable to the line-level input from a line-level output on your mixer,
* If you are using the 5VA18() with an SxA two-way system, you will want to use the high-
pass output to run the signal from, the VxAlBO to the two-way (See Figure 5). Using the
filtered output will insure that the AvAlSO only i.s reproducing low bass information which
will let the twm-way system sound cleaner and play louder. The unfiltered output is the
best way to parallel the signal to other SxAlSOs or if you want more mid-bass output from
the speaker setup.
Figure 5:
Parsel Close-up
EL^iCTRO-VOICE* Ovvrier's Manual
6