What to do if it is not possible to establish a connection with the Electro-Voice System NetMax N8000 Controller N8000 via IRIS-Net?
If you're unable to establish a connection with the Electro-Voice Controller N8000 via IRIS-Net, begin by checking the network configuration of your PC. Ensure there are no duplicate IP addresses on the network. Verify physical connectivity to rule out any cabling issues. As a last resort, try connecting directly.
General| Brand | Electro-Voice |
|---|---|
| Model | System Controller NetMax N8000 |
| Category | Controller |
| Language | English |
Essential safety guidelines to prevent hazards during operation and maintenance.
Critical instructions for qualified personnel performing service on the unit.
An overview of the NetMax system, its capabilities, and applications.
Highlights the key features and performance aspects of the N8000 System Controller.
Instructions for unpacking the unit and details regarding the warranty policy.
Guidance on installing the N8000 and an introduction to the IRIS-Net software.
Information on accessing and using the N8000's web-based browser interface.
Description of front panel elements including LEDs, signal/peak indicators, and status lights.
Details on connecting and using the USB interface for PC connectivity.
Overview of rear panel connectors for audio slots, network modules, and other interfaces.
Details on Ethernet, RS-232, and CAN bus interfaces for connectivity.
Description of the control port functionality and the mains power connection.
Guidance on physically mounting the N8000 and initial setup procedures.
Information on installing various expansion cards like audio, network, and DSP modules.
Detailed descriptions of the system's interfaces, starting with Ethernet.
Technical details and pin assignments for the CAN interface.
Further details on CAN bus operation, speed, and cable length considerations.
Descriptions of the USB connection and RS-232 interface parameters.
Final details on RS-232 interface configuration and pin assignments.
Description of the four programmable control inputs and voltage references.
Details on control port outputs (relay contacts) and example applications with switches/potentiometers.
Explanation of the READY/FAULT output and its application in life safety systems.
Wiring diagrams and recommendations for analog audio connections using XLR connectors.
Wiring diagrams for digital audio connections, both balanced and unbalanced.
Overview of network connectivity and default IP configuration for the N8000.
Guidelines for managing IP addresses, including examples of network setup and IP allocation.
Step-by-step guide to configure and test an Ethernet connection between a PC and the N8000.
Instructions for configuring the PC's IP address and subnet mask for network connection.
Steps to connect the PC to the N8000 via Ethernet and power on the unit.
Method for verifying the Ethernet connection using the ping command in the command prompt.
An example application illustrating the N8000's use in a multi-purpose hall setup.
Troubleshooting guide for resolving issues with establishing an IRIS-Net connection to the N8000.
Detailed steps for checking network configuration and physical connectivity problems.
Explanation of Ethernet networking principles relevant to the N8000.
Further details on Ethernet principles.
Explanation of IP addressing, including private IP address ranges and their usage.
Details on IP address allocation and the function of subnet masks in network configuration.
Explanation of CAN bus topology, termination, and signal ground requirements.
Discussion on CAN bus repeaters and alternative network topologies.
Illustrative examples of CAN bus wiring for different network sizes and configurations.
Performance specifications for CAN bus data transfer, including cable requirements and transfer rates.
A template for recording IP addresses, subnet masks, and gateway information for network devices.
Overview of the N8000 system controller's general description and key features.
Detailed specifications for analog audio inputs and outputs.
Specifications for signal processing, sample rates, and various system interfaces.
List and description of available expansion modules for the N8000 system.
Physical dimensions and weight specifications for the N8000 system controller.
To Next Page
